If your Jeep’s TPMS light is glowing like a campfire on your dash, don’t panic. It’s a common issue, especially after a tire rotation, seasonal temperature changes, or when switching to aftermarket wheels. This guide will walk you through how to reset the TPMS and get back to enjoying your ride.

🚨 Why Is the TPMS Light On?

The TPMS light indicates that one or more of your tires may be under-inflated, which can affect your Jeep’s handling and fuel efficiency. However, sometimes the light stays on even after correcting the tire pressure. This can happen due to:

• Tire rotations or replacements without resetting the system
• Seasonal temperature changes affecting tire pressure
• Aftermarket wheels or tires with different pressure specifications
• Faulty or aging TPMS sensors

🔧 How to Reset the TPMS in Your Jeep

1. Check and Adjust Tire Pressure

Ensure all tires, including the spare, are inflated to the recommended pressure. You can find the correct PSI on the driver’s side door placard or in the owner’s manual. It’s best to check tire pressure when the tires are cold.

2. Use the TPMS Reset Button (If Equipped)

Some Jeep models have a TPMS reset button located beneath the steering wheel. To reset:

1. Turn the ignition to the “On” position without starting the engine.
2. Press and hold the TPMS reset button until the TPMS light blinks three times.
3. Release the button.
4. Start the engine and let it run for 20 minutes to allow the system to reset.

Note: Not all Jeep models have a reset button. If yours doesn’t, proceed to the next step.

3. Drive to Reset the System

If there’s no reset button, the TPMS may reset automatically after driving. Try driving at speeds above 15 mph for at least 10 minutes. This can help the system recalibrate and turn off the TPMS light.

4. Perform a Manual Reset

If the light persists:

1. Inflate all tires to 3 PSI above the recommended pressure.
2. Deflate all tires completely.
3. Reinflate all tires to the correct pressure.
4. Drive the vehicle for 10 minutes at speeds above 15 mph.

This process can help reset the TPMS sensors.

5. Disconnect the Battery

As a last resort:

1. Turn off the vehicle.
2. Disconnect the positive battery cable.
3. Turn the ignition to the “On” position and honk the horn for about 3 seconds to discharge any remaining power.
4. Reconnect the battery cable.

This can reset the vehicle’s systems, including the TPMS.

🛑 When to Seek Professional Help

If the TPMS light remains on after these steps, it may indicate a faulty sensor or another issue. In this case, it’s best to consult a professional mechanic or visit a Jeep dealership for further diagnosis.

🚙 Looking for a Jeep with Advanced TPMS?

Modern Jeeps come equipped with advanced TPMS features for enhanced safety and convenience. If you’re in the market for a new ride, check out the latest models available.

Explore Jeeps for Sale

---

By following these steps, you can ensure your Jeep’s TPMS is functioning correctly, keeping you safe on and off the road. Regular maintenance and prompt attention to warning lights will help you enjoy your adventures without unexpected interruptions.

Comments are closed.